Turning the Phone On
Extending and retracting
the antenna
Extend the antenna to maximize signal
strength and minimize interference. When
you make or receive a call, hold the end of
the antenna and pull up until fully
extended. When you are not in a call, push
the antenna down until fully retracted.
Powering on
To turn your phone on, hold down
for about two seconds. Powering On
appears on the screen, the LED flashes
green, the phone beeps and searches for a
signal. When a service signal is found, the
standby display appears. Your phone is
ready to use.
Powering off
Hold down
for about two seconds.
PWR
The phone beeps and displays the message
To turn off: Hold down the POWER
key. You hear a second beep, then Powering
off appears on the screen. When you release
Display screen
Your phone's display screen has five information lines. Each line can
display up to 12 characters. The top line displays icons which tell you
the status of your phone. Lines two through five change depending on
the current operation. The bottom line is usually a prompt for an
operation. See the following basic examples:
Standby mode
phone status
"banner"
My Phone
time and date
12:34P 12/25
menu prompt
:Saved #s
menu prompt
:Features
The next page provides detailed information regarding your phone's display.
SB200 04-11 prep
LED
PWR
PWR
, the phone turns off.
PWR
phone status
name
phone #
menu prompt
9
CLR
PWR
1
2
3
4
5
6
8
9
7
0
#
*
Phone Book
Sony
555-1212
:Options
9
4/9/99, 2:21 PM