Download  Print this page

KitchenAid 2 CM) Installation Instructions Manual page 19

30" (76.2 cm) freestanding and slide-in gas ranges
Hide thumbs

Advertisement

Gas pressure regulator
4. Remove plastic cover from gas pressure regulator cap.
5. Turn gas pressure regulator cap (marked "LP" on front of gas
pressure regulator) counterclockwise with a wrench to
remove.
NOTE: Do not remove the spring beneath the cap.
A
B
C
A. Plastic cover
B. Gas pressure regulator cap with hollow end facing out
C. Gas pressure regulator cap with solid end facing out
D. Washer
E. Gas pressure regulator cap
6. Turn the gas pressure regulator cap over and reinstall on
regulator so that the solid end faces out and letter "N" is
visible.
7. Replace plastic cover over gas pressure regulator cap.
To Convert Standard Surface Burners
1. Remove burner cap.
2. Using a T20 TORX
®
screwdriver, remove the burner base.
3. Apply masking tape to the end of a
hold the gas orifice spud in the nut driver while changing it.
Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A
B
A. Igniter electrode
B. Gas tube opening
C. Burner cap
D. Burner base
Side view before
D
E
N
Side view after
mm nut driver to help
C
D
4. Gas orifice spuds are stamped with a number on the side.
Replace the LP gas orifice spud with the correct Natural gas
orifice spud.
A. Stamped number
Refer to the following chart for the correct Natural gas orifice
spud placement.
Natural Gas Orifice Spud Chart for Standard Surface Burners
Burner Location
Burner Rating
Right front
6,000 Btu/h
Left front
14,000 Btu/h
Right rear
12,500 Btu/h
Left rear
6,000 Btu/h
5. Place LP gas orifice spuds in plastic parts bag for future use
and keep with literature package.
6. Replace burner cap.
7. Repeat steps 1-6 for the remaining burners, except for the
TripleTier
®
Flame burner (on some models). See "To Convert
TripleTier
®
Flame Burners" section.
To Convert TripleTier
Flame Burner (on some models)
®
1. Remove burner cap.
2. Remove the burner head using a size T20 TORX
3. Remove the plate on the external gas orifice spud.
A. Burner caps
B. Burner heads
C. External gas orifice spud access plate
D. Internal gas orifice spud
A
Size
1.10 mm
1.70 mm
1.61 mm
1.10 mm
®
screwdriver.
A
B
C
D
19

Advertisement

Table of Contents
loading

  Related Manuals for KitchenAid 2 CM)