Entry Codes; Create An Entry Code; Delete An Entry Code - Sentex Crown Jewel Programming Manual

Entry Codes

Entry codes are used to open the gate or door using the Crown Jewel keypad without phoning the residence. The Crown Jewel
unit can store up to 75 entry codes. To restrict access, you can also program entry codes to activate specific relays and/or
grant access during specific Time Zones (Schedules) see page 11. Entry codes are four digits long between 0000 and 9999.
On the Crown Jewel keypad, enter the assigned "Entry Code".
If you make an error entering the code press
Before adding or modifying Entry Codes, answer the following questions:
• Have you chosen the Entry Code number you will assign? This number will be assigned to a resident. The
resident will enter this number on the unit keypad to prompt the system to grand access.
• Will the Entry Code have Time Zone (Schedule) restrictions? You may assign a Time Zone to an Entry
Code so that it is valid ONLY during specified time frames.

Create an Entry Code - 03

1. Press
2. Enter Entry Code (4-digits)
3. Press
EXAMPLES:
1
Adds Entry Code "1500".

Delete an Entry Code - 04

1. Press
2. Enter Entry Code (4-digits) to be deleted
3. Press
EXAMPLE:
1
Deletes Entry Code "1500".
1 2 3
4 5 6
7 8 9
0 #
Resident enters in Entry Code
2
2
to cancel
Resident gains access
3
3
PAGE 9