Sentex Crown Jewel Programming Manual page 25

Various Direct Commands from the Resident's Telephone - 91-97 (Continued)
E.
RELEASE RELAY 1:
RELEASE RELAY 2:
F.
G. RELEASE BOTH RELAYS: Press
EXAMPLE A:
Cycles relay #1.
EXAMPLE B:
Latches relay #1 open.
Various Direct Commands from the Resident's Telephone - 98 & 99
LATCH RELAY #1 UNTIL SPECIFIED TIME
1. Press
2. Press
3. Enter End Time (hhmm)
4. Press
Latches relay #1 open until the time of day specified. Typically used to temporarily extend an unlock schedule.
LATCH RELAY #2 UNTIL SPECIFIED TIME
1. Press
2. Press
3. Enter End Time (hhmm)
4. Press
Latches relay #2 open until the time of day specified. Typically used to temporarily extend an unlock schedule.
Multi-Unit Sites and Direct Commands from the Resident's Telephone
NOTE: If the Crown Jewel unit you wish to give a Direct Command to is part of a multi-link chain you must enter
the Crown Jewel Unit Number before entering the command number.
EXAMPLE:
1
Cycles relay #1 on Crown Jewel Unit # 5 (Data field #2 designates which unit is to respond to the direct command entered).
unknown amount of time.
Press then
Release relay #1 to its default status. Used to override existing unlock schedules.
Press then
Release relay #2 to its default status. Used to override existing unlock schedules.
then
Releases both relay #1 and #2 to its default status. Used to override existing
unlock schedules.
1 2
1 2
Example:
1
Latches relay #1 open until 11:00 AM.
Example:
1
Latches relay #2 open until 10:00 PM.
2 3
PAGE 24
Relay will activate now.
Relay will latch
open now.
2 3
2 3
Relay will activate now.
Relay will
latch open now.
Relay will
latch open now.