Delete All Entry Codes; Special Code Programming - Sentex Crown Jewel Programming Manual

Delete ALL an Entry Code - 05
1. Press
2. Enter
3. Press
IMPORTANT NOTE: This programming step erases ALL of the Entry Codes saved in the
Crown Jewel database. They cannot be retrieved unless they are saved to a CJWIN
database.
Special Entry Code Programming - 34
1. Press
2. Enter Entry Code
3. Enter one of the following Relay Codes:
0 = Cycle default relay
1 = Cycle relay #1
2 = Cycle relay #2
3 = Latch relay #1
4 = Latch relay #2
4. Enter Time Zone (1-digit) (See page 11 for information about Time Zones)
5. Press
EXAMPLES:
1
Sets Entry Code "1500" to cycle relay #1 and be valid during the times set up
for Time Zone #2
1
Sets Entry Code "1400" to cycle relay #2 and be valid 24 hours a day 7 days
a week. If a Time Zone Code is not entered as in the example above, the
Entry Code will be assigned the default Time Zone of "0" (Access All Day, everyday)
IMPORTANT NOTES: If you make an error during an entry, press the asterisk key ( ✱ ) to begin again.
The pound key (#) MUST be used to SAVE the data at the end of each programming step.
Time MUST be entered using a 24-Hour format (8:00 AM = 0800, 3:00 PM = 1500 etc.)
2 Short Beeps: Programming input is valid 1 Long Beep: Input is not valid.
5 = Release relay #1
6 = Release relay #2
7 = Release both relays
8 = Cycle both relays
9 = Latch both relays
2
2
PAGE 10
3 4 5
3 4