Call Forwarding; Setting The Call Forwarding Number; Enabling/Disabling Call Forwarding - Sentex Crown Jewel Programming Manual

Call Forwarding

The Call Forwarding feature redirects visitor calls to an outside telephone number instead of ringing the house. The forwarding
number is a regular phone number of up to 12-digits in length. You may also attach one of the following features to a forwarding
number:
• An extension of an automated switch board
• An extension (up to 6 digits) that the visitor can dial from the unit's keypad.

Setting the Call Forwarding Number - 14

1. Press
2. Enter Call Forwarding Telephone number (up to 12 digits)
3. Press
EXAMPLE:
1
Sets the Call Forwarding number as 555-1212.
NOTE: During a Call Forwarding call, the visitor will hear normal telephone line sounds, however, they will not hear the
number being dialed.
1. Press
Delete Call Forwarding Number - 14
2. Enter "00"
1. Press
3. Press
2. Enter "00"
3. Press

Enabling/Disabling Call Forwarding - 13

FACTORY SETTING: 0 (Disabled)
NOTE: To use the Call Forwarding feature, you MUST program a Call Forwarding Telephone Number..
1. Press
2. Enable/Disable Call Forwaring Mode:
0 = Disable Call Forwarding
1 = Enable Call Forwarding
2 = Enable Scheduled Call Forwarding
3. Press
EXAMPLE:
1
Enables the Call Fowarding feature.
IMPORTANT NOTES: If you make an error during an entry, press the asterisk key ( ✱ ) to begin again.
The pound key (#) MUST be used to SAVE the data at the end of each programming step.
Time MUST be entered using a 24-Hour format (8:00 AM = 0800, 3:00 PM = 1500 etc.)
2 Short Beeps: Programming input is valid 1 Long Beep: Input is not valid.
2
2 3
PAGE 16
3