Programming Basics; Procedure For Programming; System Feedback/Responses - Sentex Crown Jewel Programming Manual

Programming Basics

The Crown Jewel can be programmed 2 different ways:
1. Crown Jewel Keypad: You may used the keypad on the front panel.
2. Local/Remote DTMP Phone: You may use the keypad on a local or remote phone to program the system. The unit
response to the DTMF signals generated by your touch-tone phone.
3. Modem Connection to a PC: In order to program the Crown Jewel with a modem connection, your PC MUST be running
Sentex's Windows
The instructions in THIS manual will describe how to program the Crown Jewel from the keypad or local/remote DTMF
(Touch-Tone) phone ONLY. For More information check with your installation dealer.
Example: Procedure for Programming the Crown Jewel
1. 2 digit # Programming Number. (See Quick Reference on pages 2-3 for descriptions and procedures.)
2. One or more Data Fields.
3. Pound Key (#) at end of the programming sequence to Save the Data.
NOTES:
• If you make an error during and entry, press the asterisk key(✱) to cancel the step.
• When you correctly enter the entire programming sequence, the unit will respond with 2 short beeps (See System
Feedback/Responses (Beeps) see below).
Example of a Programming Sequence: "01 Change the Unit Password"
Enter Programming
Mode (See page 5)
System Feedback/Responses (Beeps)
Programming Responses:
2 Short Beeps:
3 Short Beeps:
1 Long Beep:
2 Long Beeps:
3 Long Beeps:
4 Long Beeps:
Busy Signal:
Direct Command Responses:
5 Short Beeps:
10 Short Beeps:
Other Responses:
1 Short Beeps:
10 Beeps:
Ring Back:
High-Low Tones:
Silence:
® -compatible CJWIN software. (See CJWIN Programming manual for more information.)
Programming Number:
"01" changes or verifies
the password.
Programming step was valid.
Programming step was exited.
Input was not valid.
Duplicate entry code was entered.
Memory is full.
Unit has reset or is powering up.
Line is busy or Do Not Disturb feature is in effect.
Gate is closing by command.
Gate is opening by command.
Key was pressed on the main keypad.
Talk time for a visitor call is ending. The unit will begin to beep when 10 seconds of talk time
remain, beeping once every second.
The unit is ringing the house.
An alarm condition has been activated.
The keypad has stuck out, unit is being programmed remotely, or an alarm condition exists.
Data Field:
(The new Password.)
PAGE 4
2 short
Exit
beeps
Programming
Mode
(See page 6)
Pound Key:
Saves the Data.