Exit Programming Mode - Sentex Crown Jewel Programming Manual

Exit Programming Mode - 00

• Press
0 0
• Press
IMPORTANT NOTES: If you make an error during an entry, press the asterisk key (✱) to begin again.
The pound key (#) MUST be used to SAVE the data at the end of each programming step.
Time MUST be entered using a 24-Hour format (8:00 AM = 0800, 3:00 PM = 1500 etc.)
2 Short Beeps: Programming input is valid 1 Long Beep: Input is not valid.
on the Crown Jewel keypad and the unit will respond with 3 short beeps when disconneting.
on the telephone and the unit will respond with 3 short beeps when disconneting.
PAGE 6