Test Mode - Bosch Carephone 62 User Manual

Carephone 62
NOTICE!
If your Carephone 62 is reset or experiences a power down, the
date and time are reset to the default value 270520091830. In
this case, the following functions are disabled:
–
–
–
This is valid until the Carephone 62 sends an alarm to a
monitoring center, allowing to set date and time remotely.
6.3

Test mode

You can set the Carephone 62 into test mode. Pressing the
wireless transmitter or the emergency call button generates an
acoustical signal without starting an alarm.
Enter test mode
–
–
–
During 3 minutes, the red lamp flashes every two seconds and
the Carephone 62 emits a short beep every five seconds.
–
–
NOTICE!
Every time the Carephone 62 receives a signal from a registered
wireless transmitter, the three-minute time frame is reset.
If no signal is received, the Carephone 62 returns to standby.
Bosch Security Systems
activity monitor in setting 99 (see step 40)
acoustical feedback in settings 2 and 4 (see step 63)
RF activation start and end time (see steps 121, 122, etc)
Press P and A together for at least one second.
The Carephone 62 announces "test".
Press 9, 0 and C.
Press the button of a registered wireless transmitter.
When the Carephone 62 receives the signal from a
registered wireless transmitter, it emits a long beep.
User Manual
Programming | en
F.01U.141.162 | V5 | 2014.09
33