Bosch Carephone 62 User Manual page 42

42 en | Operation
CAUTION!
If the person receiving the emergency call hangs up without
pressing 0, the alarm is not be properly processed. The
Carephone 62 considers that the alarm is still ongoing and
automatically dials the next destination number in the
programmed sequence. If only one destination number is
programmed, that same number will be called again.
9.
NOTICE!
Instead of the subscriber number, a personal message can be
recorded, e.g. "This is Mrs. Brown's emergency call unit...",
see Step 34 in the programming section.
Key functions on the destination phone
When the destination number is in telephone protocol, the
respective key function needs to be pressed twice in order to
confirm the selection. See programming steps 11-19 & 10.
Key Function
0 Terminate and acknowledge the call.
1 Extend the call by another 3 minutes.
2 Repeat the alarm message.
3 Speak with normal volume to the Carephone 62.
4 Listen to the Carephone 62.
5 Increase the volume and speak to the Carephone 62.
6 Reduce the volume and speak to the Carephone 62.
7 Interrupts all messages played by the Carephone 62
and switches to duplex mode (two-way operation).
8 & 0 Cancel the repeated call function for the call by pressing 8 then 0.
9 Reject the call and terminate. The Carephone 62 dials the next
number on the list.
# Remote activation of the relay output, only when programming
step 72 is set to 6, see Section 6.2.4 Programming steps, page 20.
F.01U.141.162 | V5 | 2014.09
Extend the call by 3 extra minutes by pressing 1 on the
phone. The call can be extended as often as required.
User Manual
Carephone 62
Bosch Security Systems