Bosch Carephone 62 User Manual page 24

24 en | Programming
33 Speak / Listen command audible
You can choose to hear the commands when the Carephone switches
between speak and listen in half-duplex mode.
– 0 = not audible, 1 = audible. Default value is 1.
34 Personal voice recording
For calls to telephone connections, a recorded message can be sent
instead of the subscriber's number. Maximum message length is 10
seconds.
a. Press D to start recording.
b. The unit announces "This is the social alarm unit". A signal tone
introduces the recording of your message.
c. Speak your message.
d. Recording is ended with a signal tone.
e. Press F to play back your voice recording.
To delete your voice recording, press the A key.
To end the recording early, press the E key.
This function is only available through keyboard programming.
40 Activity monitor
The time for the activity monitor can be set between 15 minutes and 31
hours in steps of 15 minutes.
a. Enter the number of hours (example: 24 for 24 hours).
b. Press C to confirm.
c. Enter 0 for 0 min, 1 for 15 min, 2 for 30 min and 3 for 45 min.
d. Press C to confirm.
Programming 00 (0 hours and 0 minutes) deactivates the activity monitor.
Programming 99 means the time frame is set by the monitoring centre or
through an SD card. This can only be used if the time and date are set. This
can be done through keyboard programming, Configuration Manager with
serial serial connection or via a remote date/time update from a receiver.
Special feature for passive alarms:
It is also possible to program an automatic activation of the sign out
status. To activate this special feature, enter 4 for 0 min, 5 for 15 min, 6 for
30 min and 7 for 45 min. In this case, any intrusion alarm will be silent. To
use this mode, at least one transmitter must be programmed as a motion
detector (see programming steps 80 to 89). Default value is 00.
F.01U.141.162 | V5 | 2014.09 User Manual
Carephone 62
Bosch Security Systems