Carephone 62
81-89 & 80 Assigning wireless transmitters
Registered wireless transmitters can be programmed to trigger different
alarm functions, e.g. a fire alarm. First, register the wireless transmitters
on the Carephone 62: refer to programming steps 90-99. To assign a
function to the wireless transmitter 91, select programming step 81.
–
0 = emergency call with a wireless transmitter (see step 50)
–
1 = emergency call with the Carephone 62 (see step 51)
–
2 = activity monitor reset with unit feedback (wireless daily button)
–
3 = sign in / sign out (see step 54)
–
4 = action button (see step 71)
–
5 = external input (when step 73 is set to 3)
–
6 = activity monitor reset without unit feedback (motion detection)
–
7 = connection to a destination number (with acknowledgement),
then enter the call sequence as a second parameter. First, press A to
delete the current value, then choose which call numbers 1 to 10 are
associated with this alarm function.
–
8 = output assigned in programming step 72
–
9 = fire alarm
–
B = motion detection
–
D = extended programming (access to these parameters with a
microSD memory card or remote programming)
If you have selected D in steps 81, 82, etc, you can choose the extended
transmitter type (111, 112, etc):
–
Panic alarm
–
Bogus call alarm
–
Stove alarm
–
Fall detector
–
Bed alarm
–
Gas alarm
–
CO alarm
–
Contact detector alarm
–
Temperature alarm
–
Flood detector alarm
–
Pull switch alarm
–
Use the custom alarm type and event handler : see steps 201, 202, etc
Bosch Security Systems
User Manual
Programming | en
F.01U.141.162 | V5 | 2014.09
29