Table of Contents
Advertisement
38
en | Programming
–
–
–
–
NOTICE!
If your Carephone 62 is reset or experiences a power down, the
date and time are reset to the default value 270520091830. In
this case, the following functions are disabled:
–
–
–
This is valid until the Carephone 62 sends an alarm to a
monitoring center, allowing to set date and time remotely.
6.3
Test mode
Pressing the wireless transmitter or the emergency call button
generates an acoustical signal without starting an alarm.
Enter test mode
–
–
–
During 3 minutes, the red lamp flashes every two seconds and
the Carephone 62 emits a short beep every five seconds.
–
–
NOTICE!
Every time the Carephone 62 receives a signal from a registered
wireless transmitter, the three-minute time frame is reset.
If no signal is received, the Carephone 62 returns to standby.
F.01U.141.162 | V6 | 2015.04
The Carephone 62 announces "setup B" and announces
the date and time value in the format DD MM YYYY HH MM
as a list of digits.
Enter the value of the date and time in the above format,
using keys 0 to 9. As soon as 12 digits are entered, the unit
determines if the date & time are valid. Do not press C.
The unit plays a sound if the input is valid or announces
"failure" if it is incorrect. If incorrect, type it again.
Exit the date and time programming mode by pressing *.
activity monitor in setting 99 (see step 40)
acoustical feedback in settings 2 and 4 (see step 63)
RF activation start and end time (see steps 121, 122, etc)
Press P and A together for at least one second.
The Carephone 62 announces "test".
Press 9, 0 and C.
Press the button of a registered wireless transmitter.
When the Carephone 62 receives the signal from a
registered wireless transmitter, it emits a long beep.
User Manual
Carephone 62
TeleAlarm
Advertisement
Table of Contents
