Removable Rear Seat - Arctic Cat BEARCAT 2015 Operator's Manual


NOTE: If moving the backrest to
the forward seat position, the pas-
senger seat must be removed.

Removable Rear Seat

Bearcat 2000 LT/Lynx
2000 LT
These snowmobiles are equipped with a
removable rear seat to allow for addi-
tional cargo space when no passenger is
being carried.

NOTE: If additional cargo is being
added, maximum weight on the snow-
mobile (operator/passenger/cargo)
should not exceed the maximum limi-
tation set for each snowmobile. See
the chart in the Suspension - Over-
load Springs sub-section in the Main-
tenance section for details. Also, the
overload springs should be engaged.
To remove the rear seat, rotate the seat
latch either clockwise or counterclock-
wise and hold it in that position; then lift
and remove the seat from the tunnel.
To install the seat, use the following pro-
cedure:
1. Place the seat into position on the
tunnel.
2. Rotate the seat latch either clock-
wise or counterclockwise and hold it
in that position; then slide the seat
forward, allow it to settle into posi-
tion, and release the latch to lock the
seat securely.
! WARNING
Make sure the rear seat is securely
locked in place before carrying a pas-
senger or personal injury may result.
18
Bearcat XT
These snowmobiles are equipped with a
removable rear seat (and on the LTD, a
removable third seat) to allow for addi-
tional cargo space when no passenger is
being carried.

NOTE: If additional cargo is being
added, maximum weight on the
snowmobile
cargo) should not exceed the maxi-
mum limitation set for each snowmo-
bile. See the chart in the Suspension
- Overload Springs sub-section in
the Maintenance section for details.
Also, the overload springs should be
engaged.
To remove the rear seat (and third seat on
the LTD), use the following procedure:
1. Remove the four pins securing the rear
seat to the seat/Speedrack mount.

NOTE: On the LTD, also remove the
two pins securing the third seat to the
seat/Speedrack mount; then lift the
742-593B
third seat up and away.
2. Lift on the back of the rear seat and
move it rearward to remove it from
the mount.
To install the rear seat (and on the LTD, the
third seat), use the following procedure:
(operator/passenger/
743-329A
0745-131