Removable Light Bar (Bearcat Xt Gs); Winch (Bearcat Xt Gs); Towing - Arctic Cat BEARCAT 2015 Operator's Manual

Table of Contents

Advertisement

1. Place the rear seat into position on
the mount making sure the four pin
holes are properly aligned with the
mounting location on mount.
2. Install the four pins making sure
they are properly seated.
NOTE: On the LTD, place the third
seat into position on the mount mak-
ing sure the two pin holes are prop-
erly aligned with the mounting
location on the mount; then install
the two pins making sure they are
properly seated.
! WARNING
Make sure the rear seat (and on the
LTD, the third seat) is securely locked
in place with the pins before carrying
a passenger or personal injury may
result.
Removable Light Bar
(Bearcat XT GS)
This snowmobile is equipped with a
removable light bar. To remove and
install, use the following procedure.
1. Disconnect the light bar harness
connector; then remove the four pins
securing the bar to the mount.
2. Remove the light bar.
3. Place the light bar into position on the
mount; then secure with the four pins.
4. Connect the light bar harness con-
nector.

Winch (Bearcat XT GS)

This snowmobile is equipped with a
winch. There are two mounting locations.
The front mounting location is for actual
use of the winch (see the winch guide)
and should not remain in this location
when operating the snowmobile. The
tunnel mounting location is for "storing"
the winch when not in use and should
remain in this location when operating
the snowmobile.
To relocate the winch, use the following
procedure.
1. Remove the receiver pin and the hair-
pin clip securing the winch.
2. Place the winch in the desired posi-
tion; then secure it with the hairpin
clip and the receiver pin.
NOTE: When operating the snow-
mobile, always have the winch in the
tunnel mounting location secured
with the hairpin clip and the receiver
pin.
0745-805

Towing

If the snowmobile is to be towed by
another snowmobile, do not tow using
the loops in the skis. The tow rope should
be attached to the spindles.
0745-806
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynx 2015

Table of Contents