Removable Seat (Zr/Xf); Towing - Arctic Cat ZR 5000 2015 Operator's Manual


NOTE: On the 9000, first unhook the
rubber straps securing the air filter
housing to the intake plenum of the
hood; then move the hood slightly for-
ward and remove the hood.
To install the access panel and hood, use
the following procedure:
1. Position the hood onto the snowmo-
bile and connect the hood harness
connector making sure the harness
does not become pinched and the
mounting screw clips are in position.

NOTE: On the 9000 prior to securing
the hood, make sure the air filter is
seated properly into the air silencer and
secured using the two rubber straps.
2. Secure the hood with torx-head
screws and tighten securely.

NOTE: On the 5000, make sure the
foam seal is in place on the air intake.

NOTE: On the 9000, make sure the
air filter housing is properly con-
nected and secured with the rubber
straps to the intake plenum of the
hood and turbocharger.
3. Install the access panel onto the lower
console; then close the access panel
and secure with the hairpin clip and
thumb screw. Install the intake panel.

Removable Seat (ZR/XF)

These snowmobiles are equipped with a
removable seat. To remove the seat remove
the screw from the underside of the seat;
then lift on the back of the seat and move it
up and rearward to remove it.
CAUTION
On the LXR prior to removing the seat,
lift the rear of the seat and disconnect
the seat heater harness connector.
To install the seat, route the front tab on
the seat through the seat-base hold-down
bracket; then install the seat and secure
using the cap screw.

NOTE: On the LXR prior to lower-
ing and securing the seat, connect
the seat heater harness connector.

Towing

If the snowmobile is to be towed by
another snowmobile, do not tow using
the loops in the skis. The tow rope should
be attached to the spindles.
746-088A
SNO-273
21