Contrast; System Programming - GE Simon XT Installation Manual

Contrast

To adjust the contrast of the display:
1. Scroll until the display shows Contrast, and then press OK.
2. Scroll to increase or decrease the contrast setting,
3. Press Status to save the setting and exit.
Note: Changes in contrast are more noticeable when not looking at the display
straight on.

System programming

To enter system programming:
1. Scroll until the display shows System Programming, and then press OK. The
system prompts for an access code.
2. Enter the access code from the codes listed in Table 9 below. The system displays
each entered access code digit as an asterisk.
3. Press OK. The panel is now in program mode.
Note: Do not remove the panel power while in program mode.
Table 9: Simon XT programming codes
Code
Dealer code
Installer code
The following sections describe the programming options in the System
Programming submenus.
26
Description
You can use the dealer code to program all system functions, including
high-security options that are not accessible with the installer code if it
is different from the dealer code. Depending on how the access code is
set, the default dealer access code is 654321, 54321, 4321 (factory
default), or 321. This code can be used for all programming.
Depending on how the access code is set, the default installer code is
654321, 54321, 4321 (factory default), or 321. This code is limited to
changing all but the following: Dealer code, code length, downloader
code, phone lock, phone #1, phone #2, phone 1 report mode, phone 2
report mode, HW1 function.
Simon XT Installation Manual