Planning; Ac, Dc, And Network Components - Xantrex RS2000 Installation Manual

Installation

Planning

AC, DC, and Network Components

6
For a successful installation, you need to plan for AC, DC, and network
components of the power system. The AC and DC components are described in
this section and illustrated in Figure 2, "Typical Recreational Vehicle Electrical
System" on page 7.
AC components include:
• Sources of AC input
• AC wiring
• Over-current protection and disconnect devices
• AC distribution panels
DC components include:
• Sources of DC power
• DC cables
• DC over-current protection and disconnect devices
Network considerations include:
• Cables, connectors, network connectors, and terminators for the System
Control Panel and Automatic Generator Start, if installing. See Figure 1.
Detailed information on planning and installing your network is available in
the Xanbus System Installation Guide. Refer to the system guide to determine
the type of network layout to install, as well as guidelines for installing the
network. This guide is available for download at www.xantrex.com
975-0126-01-01