Abus eytron Installation Manual page 19

SENSITIVITY GRADE
1 : Motion detection is slow to react and insensitive to light variation.
2-3 : Motion detection is faster and more sensitive with each step.
4 : Motion detection reacts fastest and is very sensitive to light variation.
The Sensitivity grade is applied for all cameras and can not be preset separately.
MOTION DISPLAY TYPE
CELL: Motion detection is shown by green cells.
BOX: Motion detection is shown by colourless boxes.
OFF: Motion detection is not displayed.
The Motion display Type is applied for all cameras and can not be preset separately.
RECORD DURATION
The length of time the recording is to run following motion detection.
Possible values: 1, 2, 3,...........99 sec.
The duration is applied for all cameras and can not be preset separately.
NUMBER OF CELLS TO DETECT
It will only be triggered when the cells in motion are more than the number the user has set.
So the smaller the number is, the more sensitive the detection is.
MOTION MASK SETUP
Activated Area
Deactivated Area
Press the direction keys
Press the Enter key
You can activate or deactivate individual cells or whole areas.
Marked areas are deactivated (motion in these areas is not detected) and unmarked areas
are activated.
To exit this menu item, press the menu key again (15).
Deactivating single cells or whole areas:
You deactivate a single cell by positioning the cursor on a cell and briefly pressing the Enter
key (3). The cell changes colour to grey and motion is no longer detected in this cell.
With the direction keys, move the cursor to another cell.
Activating single cells or whole areas:
You activate a single cell by positioning the cursor on a cell and briefly pressing the Enter key
(3). The cell is no longer marked, and motion detection is now active for this cell.
(2, 5, 1 and 4) to change the cursor position.
▲▼
3) to mark individual cells.
(
19