Guardcam Wf-T Installation - ESP GuardCam WF-SAR Installation And Operation Manual

GuardCam WF-T Installation

1. Place plastic masonry plugs into desired surface aligning holes as shown above. Using an
electric screwdriver, fasten mounting plate directly to surface using screws E.
2. Feed the cable through the back mounting box and bush the cable entry to avoid abrasion to the
cable.
3. Wire the unit as follows: (Ensure all wires are connected securely and that no loose strands are
exposed)
INCOMING SUPPLY
EARTH (Green & Yellow)
NEUTRAL (Blue or Black)
LIVE (Brown or Red)
4. Make sure the polarity is correct. Double check the connections after wiring. Errors may damage
the motion sensor or cause a fire hazard.
5. Attach the unit to the mounting plate. You will first need to angle the unit back so that the
catch at the top of the mounting plate fits into slot on the back of the unit. Next lower the unit
until holes at the bottom of the mounting plate and unit are flush. Then screw (screw A) into
this hole, tightening carefully.
8
Screw E
Screw E
Screw A
TO FITTING
EARTH (Green & Yellow)
NEUTRAL (Blue or Black)
LIVE (Brown or Red)