Intelli Re Ignition System Wiring - Heat & Glo SL-750TRS-IPI-D Owner's Manual

BLK
BLK
BLK
TEMPERATURE
SENSOR SWITCH
Figure 10.2
D. Intelli re Ignition System Wiring
This appliance requires a 110 VAC supply to the appliance
junction box for operation. A wiring diagram is shown in
Figure 10.3.
This appliance is equipped with an Intelli re control valve
which operates on a 3 volt system.
This appliance is supplied with a battery pack and a 3 volt AC
transformer, which requires the installation of the supplied
junction box. It is highly recommended that the junction box
be installed at this time to avoid reconstruction.
The battery pack requires two D cell batteries (not
included).
BATTERY PACK
THERMOSTAT
WIRE ASSEMBLY
Heat & Glo • SL-750TRS-IPI-D, SL-550TRS-IPI-D, SL-350TRS-C • InD • 2065-985 Rev. o • 3/07
40
VARIABLE SPEED CONTROL
JUNCTION BOX
BLK
BLK
BLK
BLK
GROUND
BLK
110-120 VAC
TRANSFORMER
3 VAC
PLUG IN
NOTE: IF ANY OF THE ORIGINAL WIRE
AS SUPPLIED WITH THE APPLIANCE
MUST BE REPLACED, IT MUST BE
REPLACED WITH TYPE 105 C RATED WIRE.
BLK
WHT WHT
GRN
WHT
Batteries cannot be placed in the battery pack while
using the 3 volt AC transformer. The transformer must
be unplugged if the battery pack is used or battery life
will be reduced.
Battery polarity must be correct or module damage will occur.
Label all wires prior to disconnection when servicing controls.
Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
IGNITION MODULE 3 VAC INTERMITTENT PILOT IGNITOR
I
S
WHITE
ORANGE
GROUND TO
FIREPLACE
CHASSIS
JUMPER WIRE
(TO BROWN)
VALVE
O
BLOWER RECEPTACLE
BLOWER
CAUTION
CAUTION