KitchenAid KFRS271TSS Installation Instructions And Use & Care Manual page 18

4. Use 10 mm socket and wrench or 10 mm nut driver to install
the new 2.1 mm orifices supplied with this kit.
NOTE: The number 2.1 is stamped on the orifice for
identification.
5. Repeat the procedure for the other burner.
6. Replace the burner top and caps. Align the notches in the
bottom of the burner top with the tabs on the burner base
and twist until the burner top is seated on the burner base.
You will feel it drop into the deep notch.
A
A. Burner top notches
B. Burner base tabs
7. Replace the side burner grates.
Change the Sear burner orifices
(for models equipped with sear burner)
1. Remove the sear burner cover screws. Set the screws and
cover aside.
A
A. Sear burner cover screws
2. Remove the burner igniter mounting screws.
3. Loosen the sear burner plate, located next to the igniter.
A. Burner igniter mounting screws
18
4. Remove the sear burner mounting screws.
5. Lift the sear burner out of the grill.
B
6. Use 6 mm socket wrench or 6 mm nut driver to remove the
7. Reinstall sear burner. Make sure that the igniter is out of the
8. Use Phillips screwdriver to reattach the igniter and sear
9. Reinstall sear burner cover. Use Phillips screwdriver to attach
Hook up to Natural gas and Leak Test
A
1. Use pipe wrench to connect certified
2. Turn on the gas supply to the grill.
3. Test all connections using an approved noncorrosive leak-
Record Conversion
A 1. The appliance nameplate is located inside the grill cabinet on
In the last page of the Use and Care Guide, write "Converted to
Natural Gas." Also record the conversion date and the
technician/company that performed the conversion.
NOTE: Place LP gas parts in plastic parts bag for future use and
keep with pack containing literature.
A
A. Sear burner mounting screws
orifice. Install the new 2.34 mm orifice supplied.
NOTE: The number 2.34 is stamped on the orifice for
identification.
way to allow proper positioning of burner. Use Phillips
screwdriver to attach the mounting screws.
burner plate.
mounting screws.
pipe to inlet side of regulator from Natural gas supply
according to local codes requirements. Use pipe thread
sealant that is certified for use with LP gas at connections
where required. There must be a certified manual shutoff
valve in the gas supply line near the grill for easy access.
detection solution. Bubbles will show a leak. Correct any leak
found.
the right-hand cabinet side. With a permanent marker, check
the box next to "Natural gas" and mark through "LP -
Propane."
" (1.3 cm) gas supply