Table of Contents
Advertisement
Section 3 – Features Overview
3.1 – AC Input Receptacle
WARNING
The TI45014D battery charger/conditioner comes with a quick disconnect ac receptacle (see Figure 3.1.1)
and is designed to plug into either a standard 120 or 240 Vac outlet with the supplied line cord (see Figure
3.1.2). See also Section 3.1a for the proper line cord for your country and region. Please ensure that the
unit is properly grounded at all times.
Figure 3.1.1 – AC Input Receptacle
(highlighted in blue)
3.1a – IEC Line Cord Options
TI25000-053 North American Line Cord
TI25000-002 Italian Line Cord
TI25000-003 Continental European Line Cord
TI25000-004 Old British Line Cord
TI25000-005 England / UK Line Cord
3.2 – AC Input Selector Switch
The AC Input Voltage Selector Switch is located below the AC Input Receptacle on the rear panel (shown in
Figure 3.2.1). This switch allows manual selection of either 120 (115) Vac or 240 (230) Vac input voltage.
To change voltage input, simply follow these steps:
1.
With cross tip screwdriver, remove one screw
and rotate the clear protective cover to one
side.
Flip the switch to desired position (115V or
2.
230V).
3.
Rotate cover back into place. Replace and
tighten screw.
TI45014D Battery Charger/Conditioner
Failure to use proper grounding can create a shock hazard.
Please refer to Section 4.2 for proper grounding techniques.
Figure 3.1.2 – Connecting AC line cord
TI25000-006 Swiss Line Cord
TI25000-011 Australian Line Cord
TI25000-200 Israel Line Cord
TI25000-300 Denmark Line Cord
Figure 3.2.1 – AC Input Selector Switch
(highlighted in blue)
9
Advertisement
Table of Contents
