Teleflex 301 Owner's Manual page 89

DISTRIBUTION BOX 1. T h e top cover is held on by four screws. Remove
This
these screws to completely remove this cover. all
is
is required to connect the wires. Proceed further
t h a t
only
if troubleshooting the
unit.
2. Remove the cable clamps to allow cable removal. See
6 B
the drawing on page Section for the wiring layout.
3.
Remove the knobs from the side to remove the entire
.
distribution box for service, leaving the bracket in place.
.
c
and Troubleshooting
Servicing
section