To Change Course; Autopilot Control - Teleflex 301 Owner's Manual

TO CHANGE COURSE

AUTOPILOT CONTROL

AUTO/STANDBY
section A
.
SELECT COURSE CHANGE FUNCTION:
. 1.
With pilot in AUTO mode, press
.
lamp is not Note: the light will flash if the pilot is in
lit.
.
standby.
CHANGE COURSE TO PORT
2.
.
Press the red button. Port rudder
display o n the Keyboard
.
CHANGE COURSE TO STARBOARD
3.
.
button.
Press the green
the display o n the Keyboard Console will change to show
the new course.
The vessel often turn slower than the course
will
changed. Release button before the new course is
.
reached and approach
.
cations of the button. T h e display o n the Keyboard
.
Console indicates the new course selected
By
both
pressing dodge buttons
autopilot will toggle between
AUTOPILOT
modes.
engage the autopilot from the remote, press
buttons a t the same time. Likewise, if you are in autopilot
mode and wish to go
at
the same time.
"SELECT"
(Left):
applied and the
is
Console
will change to show the
Starboard rudder is applied and
the desired course by short appli-
the same time the
a t
STANDBY
If
you are in standby and wish
both
to standby, press
Operating
if the course
(Right):
being
is
instantly.
and
to
both
dodge
buttons
dodge
Instructions