Table of Contents
Advertisement
Motor drives rudder
hard over when pilot is
Error messages appear
when NAV PILOT pressed
Section C
.
Rudder reference red and black wires reversed.
Motor wires reversed.
engaged
Indicates t h a t no signals have been received on the NAV
port. Check the NAV
Board
.
If
possible, check that the navigation receiver
.
data.
Check wiring. A two wire cable should be connected to
the cable. The centre conductor should
.
Indicates a loss of navigator signal or incorrect format.
The time out period for
tion is
Check that correct format is entered o n the Nav.
Check navigator wiring.
The comments that
, Indicates that the navigation receiver has sent an invalid
character or statement.
This may be caused
with the pilot already turned
.
navigation receiver
.
receiver's manual.
If
this message occurs repeatedly, suspect intermittent
wiring, noise on the line
ceiver.
*
LED
which flashes to indicate incoming data.
SIC-. If
and
you are unsure
and the shield to
loss of cross track error informa-
60
seconds.
follow
by
turning on the navigation receiver
and
continue. Consult your nav
on the Distribution
of the polarity, reverse
be
connected to
also apply.
on. Reset the error on the
or
defective navigation re-
a
and
PC
Box
sending
is
Troubleshooting
Advertisement
Table of Contents
