Table of Contents
Advertisement
TO CHECK RUDDER
ANGLE, COURSE ERROR
AND CROSS TRACK
TO ADJUST
BACKLIGHTING
NAVIGATOR OPERATION
REMOTE CONTROL
OPERATION
Section A
Press DISPLAY/SET once.
A
graphic display appears and will differ depending on
.
which mode you are in.
ERROR
1 .
From standby mode, the display shows rudder angle.
From autopilot mode,
on the top
From Nav mode, the display shows any cross track error
on the top
.
2. Cross
.
display shows 'XTE <W,
.
depending on what cross track error information
.
available.
3.
Press DISPLAY/SET a third time to return to the
original display.
.
Press the DISPLAY/SET button and
The light level increases to
to zero intensity. Release the button when you reach the
desired intensity.
.
Press NAV
lot mode from either standby or autopilot mode.
nav data is present, the display shows
3
seconds, then it reverts
system remains in its previous mode.
.
However, unless you have programmed the navigation
.
receiver and reduced any crass track error, the vessel may
.
experience an unexpected course change.
.
TOR OPERATION
See page
the
display shows any course error
half
and rudder angle on the bottom half.
half
and rudder angle on the lower.
track error. When you push a second time, the
full
PILOT
to engage navigator controlled autopi-
to
its previous display and the
on page
13
for
full
Section A
a
"XTE >O<'',
hold
for 3 seconds.
it
intensity, then dims down
"NO
N A V G R for
See
NAVIGA-
19
A.
Section
description.
Instructions
Operating
is
If
no
Advertisement
Table of Contents
