Table of Contents
Advertisement
KEYBOARD CONSOLE
c
section
the
1.
Remove
Keyboard Console from its bracket or
from the instrument panel. W h e n
unit will pass through the hole in the instrument panel
for removal.
2. Remove the four screws from the rear
knob
3.
Remove the
the front panel away from the rear and unplug
printed circuit.
4.
To
remove the circuitry for service, remove the two
the printed circuit then unplug the input
screws holding
cable's connector from the printed circuit.
5. When re-assembling the unit, reverse the above
procedure and make sure that the flexible strip
remember to install the ring around
encoder.
flush
is
it
with a
1.5 mm Allen wrench. Ease
the course change
Servicing
mounted the
of
the case.
from the
it
the
to
and Troubleshooting
Advertisement
Table of Contents
