Table of Contents
Advertisement
section
A
7. ALARMS
a
If the Navigation receiver indicates a n alarm condition,
such as loss of signal, the Teleflex 301 will display "NAV
TIME
DATA", "NAV
dible alarm. The pilot will hold the vessel on its present
heading and will not accept any further changes from the
a
nav receiver until the nav receiver signals the autopilot
t h a t the data is good again. The Navigation receiver
may also indicate this alarm condition. See the instruc-
for your nav receiver for further information.
tions
a
For many fault conditions, pressing "DISPLAY/SET" will
give you a message concerning possible reasons
alarm ocurred. To clear the alarm press "STANDBY/
ON"
manually steer the vessel or "AUTOPILOT"
to
you wish to revert
a
gator controlled operation once the nav receiver has
a
indicated the fault has cleared.
Alternately) you may press "NAV PILOT"
is still bad the autopilot will give another alarm.
interruption of signal was only momentary, navigator
a
controlled steering will resume. If the alarm will not
clear, turn the pilot off then on and resume autopilot
control under compass control or steer the vessel manu-
ally.
a
a
a
a
or other messages
compass control. Re-engage navi-
to
and
give an au-
the
why
if
but
the data
if
If
the
Operating Instructions
Advertisement
Table of Contents
