Clarity Wildcat WN-4030-S Service Manual page 23

1. When the lamp is lit, the ballast sends a signal to
the electronics module, and the Standby LED goes
out. The Lamp LED turns on.
" " " ! " " $ $ $ $ #
Standby state: Standby
LED is on steadily, no
AC Power Up
Electronics
initializes itself
Lockout state: Standby LED
is flashing slowily, one flash
flashing
Lockout:
30 seconds
per second
Interlock opens
Standby
RS232 PON
Remote Lamp On
No
Yes
Auto Lamp On
Enabled?
Interlock opens
Remote Lamp Off
RS232 POF
Interlock opens
Remote Lamp Off
RS232 POF
Lamp Delay, if
any, from Misc
Control menu
Ignition state: Standby LED
is flashing quickly, two
flashes per second
Lamp Ignition
Lamp On state: Standby
Lamp On
LED is off
15