Heinner MGL-12B User Manual page 17

www.heinner.com
IX. MAKING SOUSAGES
1. Mince the meat
Insert the worm shaft into the cutter housing , the plastic end first.(fig.11)
-
Place the separator in the cutter housing.
-
Place the sausage horn on the cutter housing and screw the ring on the cutter
-
housing.
(Make sure the notches of the separator fit onto the projections of the mincer head.)
2. Attach the cutter housing to the motor unit.
3. Place the tray on the upright part of the cutter housing.
4. Now the appliance is ready for making sausages.
Put the ingredients in the tray. Use the pusher to gently push the meat into the cutter
housing. Put the sausage skin in lukewarm water for 10 minutes. Then slide the wet skin
onto the sausage horn. Push the (seasoned) minced meat into the cutter housing. If the
skin gets stuck onto the sausage horn, wet it with some water.
Feed the prepared kebbe mixture through the kebbe maker. Cut the
continuous hollow cylinder into the desired lengths and user as required.
Kebbe is a traditional Middle Eastern dish made primarily of lamp and
bulgur wheat which are minced together to form a paste the mixture is
extruded through the kebbe maker and cut into short lengths. The tubes
can then be stuffed with a minced meat mixture, the ends pinched
together and then deep fried.
1200W, 50/60Hz, 220-240V
16