Fuser Page Count
The value of this setting indicates the total number of pages that have been printed by the fuser in the space below
the header.
To view the fuser page count:
From the Diagnostics menu, navigate to EP Setup > Fuser Page Count.
Note: The value of the setting cannot be changed manually.
Warm Up Time
This setting controls the amount of time the printer warms up before allowing pages to print. The range of values is
between 0 and 5, where 0 is no warm‑up time and 5 is up to 90 seconds of warm‑up time.
To change this setting:
From the Diagnostics menu, navigate to EP Setup > Warm Up Time.
Transfer
This setting controls the transfer roll algorithm.
To adjust this setting:
1
From the Diagnostics menu, navigate to:
EP Setup > Transfer
2
Press Back.
Print Contrast
This setting controls the developer voltage offset.
To adjust this setting:
1
From the Diagnostics menu, navigate to:
EP Setup > Print Contrast
2
Press OK or touch
Charge Roll
This setting controls the charge roll voltage.
To adjust this setting:
1
From the Diagnostics menu, navigate to:
EP Setup > Charge Roll
2
Press OK or touch
to save any changes.
to save any changes.
Service menus
235
4063