Sensor (Media In Stapler) Jam Service Check - Lexmark MS81 Series Service Manual

Sensor (media in stapler) jam service check

Action
Step 1
Is the staple finisher the only output option installed?
Step 2
Remove all output options and re-install only the staple finisher.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the auto connector end of the option previously installed below the
staple finisher.
Is it free of damage?
Step 4
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Stapler lower interface cable removal" on
page 484.
Remove the left cover. Reseat the cable (J15) on the controller PCBA, then
POR the machine.
Does the error remain?
Step 5
Check the sensor flag (media in stapler):
•
for damage
•
if it moves freely when manually actuated
Is the above component ok?
Step 6
Open the left cover, reseat all connectors on the controller PCBA and then
POR the machine.
Does the error remain?
Yes
Go to step 4.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 4.
Go to step 5.
Go to step 6.
Replace the controller
PCBA. Go to
controller PCBA
removal" on page
486.
If the error persists,
then replace the staple
finisher assembly. Go
to
assembly removal" on
page
Diagnostic information
190
No
Go to step 2.
Go to step 3.
Replace the upper
interface cable of the
output option under
the staple finisher.
The problem is solved.
Replace the staple
finisher assembly. Go
to "Staple finisher
assembly removal" on
page
The problem is solved.
"Stapler
"Staple finisher
461.
4063
461.