Mailbox Diverter Jam Service Check - Lexmark MS81 Series Service Manual

Action
Step 16
Re-seat all the connectors on the controller PCBA. POR the machine.
Does the error remain?

Mailbox diverter jam service check

Action
Step 1
Is the mailbox the only output option installed?
Step 2
Remove all output options and re-install only the mailbox.
Enter Diagnostics Menu and navigate to:
Output bin tests > Feed to all bins
Does the output option feed to all bins normally?
Step 3
Check the auto connector end of the option previously installed below the
mailbox.
Is it free of damage?
Step 4
Check the lower interface cable. If damaged, then replace the lower
interface cable. Go to "Mailbox lower interface cable removal" on
page 500.
Re-seat the connector (J1A) on the controller PCBA, then POR the
machine.
Does the error remain?
Yes
Replace the controller
PCBA. Go to
controller PCBA
removal" on page
497.
If the error persists,
then replace the
mailbox assembly. Go
to
removal" on page
490.
Yes
Go to step 4.
The problem may not
be on this option tray.
Re‑install the
remaining output
options one at a time
and test each option
for errors. Proceed
with the appropriate
service check based on
the error message and
the output option
being tested.
Go to step 4.
Go to step 5.
Diagnostic information
170
No
The problem is solved.
"Mailbox
"Mailbox assembly
No
Go to step 2.
Go to step 3.
Replace the upper
interface cable of the
output option
previously installed
under the mailbox.
The problem is solved.
4063