Using A Touchtone Phone To Operate Your System; Phone Command Prefix - GE Concord Ultra User Instructions

Using a
Touchtone
Phone to
Operate Your
System
Concord Ultra
User information is shown in the following table.
Detail Screen Display
U001 - U096
U600 - U829
U830
U831
U838
U839
U846
U847
U848
U849
U850
U851
U852
Source information is shown in the following table.
Detail Screen Display
S00
S01
S02
S06
S08
S09
S1xx (xx = Zone Number)
S3xx (xx = Bus Unit Number)
S6xx (xx = Bus Unit Number)
Your system is equipped with a Phone Interface and Voice Module that allows system operation
from a Touchtone phone on or off the premises (if enabled by your installer).
The module contains a digital-voice chip, enabling programmed text to be spoken through the
phone and/or broadcast through interior speakers. Except for custom words, the voice will speak
the text that appears on alphanumeric touchpads in the system.

Phone Command Prefix

What distinguishes a call to the panel from any other out-going or incoming call is the use of the
Phone Command Prefix:
• In the case of on-site operation, if the Phone Command Prefix is dialed first (within 5 seconds
of picking up the phone), the panel pricks up its ears and waits for a valid access code or com-
mand.
• If the system is being accessed remotely, the Phone Command Prefix is used in conjunction
with the access code.
#
The prefix is usually , but can be changed to
*
use as the first key you press instead of
Wireless Touchpad or Keyfob
Regular User Codes 000 - 229
Partition 1 Master Code
Partition 2 Master Code
Partition 1 Duress Code
Partition 2 Duress Code
System Master Code
Installer Code
Dealer Code
AVM Code
Quick Arming
Keyswitch Arming
System
Source
Premise Phone
Phone During Conversation
Remote Phone
Auto Stay Arming
Keyswitch Arming Zone
System
Keychain Touchpad or Wireless Touchpad
Alphanumeric Touchpad
Fixed Display Touchpad
*
by the installer. If your prefix has been changed,
#
.
User
33