Cb Radio Wiring; Coach Leveling System - Winnebago 2000 Freedom Operator's Manual

CB RADIO WIRING

(Optional)
Your coach is pre-wired for CB radio installa-
tion. The wires are located beneath the dash to the
left of the steering wheel.
Look for a pair of wires, yellow (+) and white
(-), with connectors and flag labels, suspended
from the wiring harness.
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.
SWR Adjustment
To adjust CB antenna SWR (standing wave
ratio), turn the adjusting rings of the antenna to
achieve the lowest SWR reading. This procedure
will help optimize transmitting and receiving ca-
pabilities of the radio system.
TO
CB RADIO
CB POWER PROVISION
CB POWER PROVISION
Purple
RED
Green
BLACK
Coax
COAX
(See Reverse Also)
(SEE REVERSE ALSO)
CB ANTENNA
CABLE
CB Radio Wiring
TO
CB RADIO WIRING
+12 V LABEL
+ 12 V
Ground
GROUND
Antenna
ANTENNA
WIRE ASM-IP,MAIN
DRIVING YOUR MOTOR HOME
CAUTION
The CB radio could become damaged
if CB antenna SWR is not adjusted
before operating CB radio.
AUTOMATIC COACH
LEVELING SYSTEM
Your coach may be optionally equipped with
a 4-point HWH computerized, automatic, hy-
draulic leveling system.
This leveling system is designed to diminish
problems in selecting a parking site, making "set
up" easier and faster for you.
See the HWH Operator Manual in your
Owner's InfoCase for complete operating in-
structions. It also contains additional precautions,
technical information, and instructions for manu-
al operation if automatic functions fail.
The leveling system control panel is located
on the driver's side armrest panel.
SECTION 2
2-19