Connecting To The Gps Receiver - JRC JMA-5212-4 Installation Manual

3.6

CONNECTING TO THE GPS RECEIVER

3.6.1 When using JRC's GPS receiver
1) Connection
When using JRC's GPS receiver, such as GPS100/DGPS212, directly connect the GPS receiver to the
connector for which "GPS" is engraved at the rear of the radar process unit cabinet. Turn the plug
attached to the connector until it cannot be turned any further.
F1 F2 F3
POWER
E
2) Setting of the GPS receiver of JRC
No setting is required.
3) Setting the JMA-5200MK2
Basically, no setting is required.
No special setting is required for the use.
However, to change the setting for selecting or restricting the sentences to be received, change the setting
as described in "4.8 COMMUNICATION PORT SETTING (COM PORT SETTING)".
SCANNER
GPS KEY BOARD
The JRC's GPS receiver is connected here.
3-10
AUX
VIDEO
GYRO AIS
COMPASS NMEA
3
NMEA