Attach The Camera - Uniden G17xx Series Owner's Manual

Attach the Camera

2
3
Loosen the
wingnut to
unlock the
mounting
post.
1. For each camera, attach the camera bracket to the mounting screw. You can
attach the stand to the top or the bottom of the camera as needed. Tighten it a
few turns, then turn the camera to face the direction you want.
2. Tighten the camera brace up against the camera to secure it into place.
3. Unlock the mounting post by turning the wingnut a few turns to the left.
4. Set the mounting post to the correct angle, then tighten the wingnut until the post
is locked into place.
5. Attach the antenna to the rear of the camera.
Power Up the Camera
1. Connect one end of an AC adaptor to the camera's power pigtail and plug
the other end into a 240 volt AC (standard indoor) power outlet. (If necessary,
connect the extension cord to the camera's pigtail and connect the AC adaptor to
the extension cord.)
# Be sure the power plug and the connector are tightly twisted together to avoid
water leaking in.
2. Make sure the Power status light turns on. If it doesn't, try reconnecting the AC
adaptor, and make sure the power outlet isn't controlled by a wall switch.
Tighten the brace against
the camera to
secure it
in place.
Attach the camera
1
to the mounting
screw and turn it
to the desired
direction.
Adjust the post to
4
the correct angle,
then tighten the
wingnut to lock the
post into place.
9