Attach The Camera; Adjusting The Sun Shield - Uniden UDW20055 Owner's Manual

Attach the camera

1. Attach the camera bracket to the mounting screw.
Tighten it a few turns, then turn the camera to face the
direction you want.
Tighten the brace against Tighten the brace against
2 2
the camera to the camera to
secure it secure it
in place. in place.
3 3
Loosen the Loosen the
wingnut to wingnut to
unlock the unlock the
mounting mounting
post. post.

Adjusting the Sun Shield

If there is too much glare in the camera, you can move the sun shield forward to provide more
shade for the lens. If the top of the picture is cut off, try moving the sun shield back.
To adjust the sun shield, loosen the bolts on the side of the mounting bracket (see page 7). Slide
the sun shield forward or back, then check the picture in the receiver display. When the picture is
satisfactory, tighten the bolts again.
8
Attach the camera Attach the camera
1 1
to the mounting to the mounting
screw and turn it screw and turn it
to the desired to the desired
direction. direction.
Adjust the post to Adjust the post to
4 4
the correct angle, the correct angle,
then tighten the then tighten the
wingnut to lock the wingnut to lock the
post into place. post into place.
2. Tighten the camera brace up
against the bracket to secure it
into place.
3. Unlock the mounting post by
turning the wingnut to the left
a few turns.
4. Set the mounting post to the
correct angle, then tighten the
wingnut until the post is locked
into place.