Advertisement
turns, then turn the camera to face the
direction you want.
Tighten the camera brace up against the
2.
camera to secure it into place.
3. Unlock the mounting post by turning the wingnut to the left a few turns.
4. Set the mounting post to the correct angle, then tighten the wingnut until the post is locked
into place.
Attach the antenna to the rear of the camera.
5.
6. Connect one end of an AC adapter to the camera's
power pigtail and plug the other end into a 120 volt
AC (standard indoor) power outlet. (If necessary,
connect the extension cord to the camera's pigtail
and connect the AC adapter to the extension cord.)
Make sure the Power status light turns on. If it doesn't,
7.
try reconnecting the AC adapter, and make sure the
power outlet isn't controlled by a wall switch.
1. For each camera,
attach the camera
bracket to the
mounting screw.
You can attach the
stand to the top or
the bottom of the
camera as needed.
Tighten it a few
Tighten the brace against
2
the camera to
secure it
in place.
.
Attach the camera
1
to the mounting
screw and turn it
to the desired
direction.
2
4.Adjust the post to
4
the correct angle,
then tighten the
wingnut to lock the
post into place.
Antenna
Power
(Link button
not shown)
7
Advertisement
