Set Up The Monitor; Pairing Accessory Cameras To The Monitor - Uniden G17xx Series Owner's Manual

set up the Monitor

1. Remove the protective plastic from the monitor screen.
2. Flip out the stand on the back of the monitor and extend the antenna.
3. Connect an AC adaptor to the power input on the side of the monitor.
4. Connect the other end of the adaptor to a 240 volt AC (standard indoor) power
outlet.
5. Press and hold the
power it up.
If...
there is no camera picture
the picture quality is poor
a white image appears at night
6. The monitor displays the Uniden title screen and then displays the LIVE view.
7. After the system powers on, adjust the camera viewing position if needed.

Pairing Accessory Cameras to the Monitor

The cameras that come with your G17xx Series are paired to your monitor at the
factory. To pair the camera to the monitor, follow the steps below.
1. Press M and access the main menu. Then select CAmerA Setup and press
Scroll to the camera number you want to assign to the new camera. Press
CH+
2. Press to scroll to the pairing option. Press
3. Within 30 seconds, press the
10
PoWeR
button on the top of the monitor for 1 - 2 seconds to
Try...
Verify that the power supply adaptor for the
camera(s) is plugged in.
Clean the camera lens.
The camera's infra-red LED shines due to the
invisible light that reflects off surfaces such as
glass, causing white light. Place the camera
on the other side of windows with the lens side
flush against the surface to improve the night
vision, or place the camera in a well-lit area.
PAIRInG
M
to pair the camera.
button on the camera's power cord.
Pairing Button
M
.
M
.