Ubee DDW262.G User Manual page 52

Using the Wireless Radio Option
this screen example.
48
Label
Wireless Interfaces
Wireless
Country
Output Power
802.11 n-Mode
Bandwidth
Sideband for Control
Channel (40 Mhz only)
Control Channel
Regulatory Mode
Pre-Network Radar Check
Ubee DDW262.G Wireless Cable Modem and Router Subscriber User Guide • September 2011
Description
Displays the Wireless SSID and MAC address of the wireless
interface.
Displays the wireless radio's status, Enabled or Disabled.
Defines the country where you use this device. When set to
USA, channels 1 to 11 are available. If selecting worldwide,
13 channels are available.
Sets a percentage of output power to use for the wireless
radio transmitter.
Sets the wireless networking standard. Select Auto to use
802.11 n mode when possible.
Sets the bandwidth to 20Mhz.
Not available for this device.
Selects a specific channel 1-11 to deploy the wireless
network. This allows you to set the operating
frequency/channel depending on your particular region.
Channel selection can have an impact on wireless networking
performance. For more information, refer to
Wireless Channel on page
Defines whether Regulatory Mode is set to off, 802.11d, or
802.11h.
Defines the number of seconds to check for radar on a
channel before establishing a network. Current specs specify
60 seconds. Range 0-99. Zero disables checking. Designed
so APs avoid channels that contain radar systems. Used for
802.11h only.
Ubee Interactive
Selecting a
57.