Configuring System Ports (Connection) - FLIR M3100 SERIES Instruction Manual

15 Using the Main Menu
2. Under Mode, select DHCP (recommended) to let the system automatically obtain an
IP address from the router or Static to assign a static IP address.
If you select Static, configure the following:
• IP Address: Enter the IP address you would like to assign to the system. Make sure
that no other device on your network is using the same IP address.
• Subnet Mask: Enter the subnet mask for your network.
• Default Gateway: Enter the gateway address for your network.
• Preferred DNS: Enter the address of your primary DNS server.
• Alternate DNS: Enter the address of your secondary DNS server.
3. Click OK to save changes.

15.3.3 Configuring System Ports (Connection)

The Connection menu allows you to configure ports used by the system. Please note that
port forwarding is not required to use FLIR Cloud™ or to connect using the apps.
If you are using DDNS connectivity, port forwarding is required for the HTTP Port (defaut:
80) and TCP (Client Port) (default: 35000).
To configure system ports:
1. From the Main Menu, click
2. Configure the ports as needed and click OK to save changes.
Note
Up to 3 devices may connect to the system at the same time when using FLIR Cloud™.
#LX400028; r. 1.0/16141/16141; en-US
and then select Network>Connection.
50