Resetting Jobs (Welding Tasks) To The Factory Settings; Resetting A Single Job - EWM Phoenix 355 Progress puls MM TDM Operating Instructions Manual

Rectifying faults

Resetting JOBs (welding tasks) to the factory settings

7.3 Resetting JOBs (welding tasks) to the factory settings
7.3.1

Resetting a single JOB

All customised welding parameters that are stored will be replaced by the factory
settings.
Display
44
ENTER
3 s
JOB-
LIST
Setting/selection
Reset to factory settings
The RESET will be done after pressing the button.
The menu will be ended when no changes are done after 3 sec.
JOB-number (example)
The shown JOB will be set to ex works.
NOTE
RESET
Figure 7-1
3 s
JOB-
LIST
EXIT
3 s
099-005320-EW501
22.05.2014