9.11 SPeed SeNSor rePlaCemeNT
1) Unplug treadmill.
2) remove front shroud as outlined in Section 9.1.
3) remove speed sensor from the left side of the motor using a Phillips screwdriver (figure a).
4) Cut the wire ties holding the speed sensor wire to the motor and mCb (figures b & C).
5) Unplug speed sensor from mCb (figure d).
6) auto Calibration must alWayS be run after installation of a new speed sensor.
fiGUre a
fiGUre C
CHaPTer 9: ParT rePlaCemeNT GUide
fiGUre b
fiGUre d
45