Deck Removal - Matrix T5X-02 Service Manual

CHaPTer 9: ParT rePlaCemeNT GUide
9.3 DeCK reMoVAL
1) remove the front shroud as outlined in Section 9.1.
2) remove four deck screws using a 5mm allen wrench (figure a).
3) remove the deck from the running belt (figures b & C).
4) be careful not to pinch fingers during removal / installation of deck board.
5) deck is waxed on both sides so opposite side surface may be usable.
5) New deck surfaces must alWayS be matched to a new running belt.
fiGUre b
fiGUre a
fiGUre C
37