3-92
016-311 Scanner Not Detected
[Detection Conditions] The system detected that the
Scanner was not installed.
[Actions]
Turn the power On/Off and perform the following if
the problem persists.
(1) Reinstall the Scanner.
016-315 IIT Interface Failure
[Detection Conditions]
An error in the I/F between the Scanner and the Main
Unit was detected
[Actions]
Turn the power On/Off and perform the following if
the problem persists.
(1) Install or replace the I/F between the Scanner and
the Main Unit.
016-316 Page Memory Not Detected
[Detection Conditions]
The system detected that the Scanner's Page Memory
(standard) was not installed.
[Actions]
Turn the power On/Off and perform the following if
the problem persists.
(1) Install the Scanner's Page Memory (standard).
016-317 Page Memory Broken- Standard
[Detection Conditions]
The system detected that the Scanner's Page Memory
(standard) has an error.
[Actions]
Turn the power On/Off and perform the following if
the problem persists.
(1) Replace the Scanner's Page Memory (standard).
016-318 Page Memory Broken
[Detection Conditions]
The system detected that the Scanner's Page Memory
has an error.
[Actions]
Turn the power On/Off and perform the following if
the problem persists.
(1) Replace the Scanner's Page Memory.
016-450 Duplicate SMB Host Name
[Detection Conditions]
A PC with the same host name already exists on a
network.
[Actions] Change the host name.
016-452 Duplicate IP Address
[Detection Conditions]
A PC with the same IP Address already exists on a
network.
[Actions] Change the IP Address.
016-453 DHCP Server IP Address Fetch Failure
Occurred
[Detection Conditions]
The DHCP Server failed to grant an IP Address.
[Actions]
Set the IP address. (Fetching IP Address from the
DHCP Server is not performed.)
016-454 Dynamic DNS - Dynamic Update Failed
[Detection Conditions] Dynamic DNS - Dynamic Update
Failed
[Actions] Turn the power On/Off.
Chapter 3 Troubleshooting
016-460 HDD FULL Status Was Detected.
[Detection Conditions]
During HDD access, HDD Full status was detected.
This is an error that FULL is cleared even during wait
for timing.
[Actions] Depends on the service operation specification.
016-500 Scan-to-Email Failure
[Detection Conditions]
While receiving from an SMTP Server an IP Address
error occurred.
[Actions]
Specify the correct SMTP Server Name or IP Address.
016-501 Scan-to-Email Failure
[Detection Conditions]
While receiving from a POP Server an IP Address
error occurred.
[Actions]
Specify the correct POP Server Name or IP Address.
016-502 Scan-to-Email Failure
[Detection Conditions]
While receiving from a POP Server an Account
Information error occurred.
[Actions]
Specify the correct POP Server Account Information.