Logging In To The Thermostat - Proliphix IMT350c Installation Manual

Beta Draft Confidential
Verifying the Thermostat's Operating Status
This section describes the procedures you can use to verify that the heat, cool, and fan
controls are operating properly on your thermostat. Before you begin, verify that the
HVAC system's power is set to "On" and HVAC on the thermostat lcd panel is set to
"Auto".
Testing the Heat Controls
Verify the HVAC mode is set to either Auto or Heat.
1
Continuously press the Up arrow until the heat set point is higher than the temperature
2
reading.
A flame icon appears within 30 seconds, and the HVAC system activates the heat.
Testing the Cool Controls
Verify the HVAC mode is set to either Auto or Cool.
1
Continuously press the Down arrow until the cool set point is lower than the
2
temperature reading.
A snowflake and fan icon appears within 30 seconds, and the HVAC system activates
the cool and fan.
Testing the Fan Operation
Press the fan button until the mode is set to On. A fan icon appears within 30 seconds,
and the fan circuit is now active.

Logging In to the Thermostat

Log in to the IMT350 Web pages as the Administrator as follows:
Obtain the IMT350's IP address from the LCD interface.
1
Enter the IP address into your browser.
2
Log in using the default user name of "admin" and the password of "admin".
3
Proliphix Internet Managed Thermostat (IMT) 350c/350w Installation Guide, Release 1.0
Part No. 600-03000-350, Rev. 1
Logging In to the Thermostat
15