Table of Contents
Advertisement
Installing and Wiring the Thermostat
The IMT350c can be powered from different sources presented on the following
Ethernet CAT5/5E/CAT6 interface (see
A Power over Ethernet (PoE) source is an Ethernet router, switch, or mid-span
device that complies with the 802.3af Power over Ethernet standard. (IMT350c
only)
Proliphix Ethernet Power Adapters (EPA) are multi-port power injectors capable
of supplying power to either two (EPA-20) or six (EPA-60) Proliphix Network
Thermostats. (IMT350c and IMT350w)
24VAC is power from the HVAC system which requires RH and C to both be
connected to provide power to the thermostat. (IMT350c and IMT350w)
Figure 6
Figure 6 Power Sources
Table 8
Table 8 Power Source Configuration
Switch
SP1
SP2
SP3
SP4
To mount the thermostat into the base plate:
Mount the thermostat into the base plate (see
1
into the corresponding receptacle holes in the top of the base plate.
Snap the bottom of the thermostat securely into the base plate.
2
14
Proliphix Internet Managed Thermostat (IMT) 350c/350w Installation Guide, Release 1.0
Beta Draft Confidential
shows the four power sources.
shows how to configure the IMT for different power sources.
PoE
Off
Off
Off
Off
Figure
6):
EPA
24 VAC/HPA
On
On
On
On
Off
On
Off
On
page
5) by inserting the top two hinges
Part No. 600-03000-350, Rev. 1
- Quick Links:
- Logging in to the Thermostat
Hide quick links:
Advertisement
Table of Contents
