Configuring Switch Settings; Configuring Alarm Input Devices - FLIR DNR300 SERIES Instruction Manual

14 Using the Main Menu

14.2.13 Configuring Switch Settings

You can configure the networking settings for the internal PoE switch.
CAUTION
Changing this information from the default values may disrupt the connection to the cameras. Make sure
your IP cameras are using DHCP or IP addresses that are compatible with your selected settings.
To configure switch settings:
1. Click Network Setting.
2. Double-click Switch Settings.
3. Configure the IP Address, Subnet Mask, and Gateway for the internal PoE switch.
4. Click OK. Click Save to save changes. The system will restart.

14.2.14 Configuring Alarm Input Devices

You can connect alarm input devices such as motion sensors (not included) or glass break
detectors (not included) to the system. The system can be set to trigger recording or take
other actions when these devices are activated.
To configure alarm input devices (not included):
1. From live view, right-click and select Main Menu. Log in if prompted.
2. Click Setting>Alarm.
3. Configure the following to activate an alarm input device:
• Alarm In: Select the alarm input port the device is connected to.
• Enable: Check to enable the alarm input device connected to the selected port.
• Type: Select Normal Open or Normal Close depending on the type of alarm input
device you have.
• Alarm: Change the name of the alarm input device.
#; r. 2.0/23094/23094; en-US
40